![]() To implement the change, the selected parameter must be blinking.ĭata increment (increase) – raises the value of the selected parameter (e. Parameter selection – used to select the parameter to be changed (e. Programming step – used to select the appropriate programming mode (e. The Computerized Irrigation Controller is programmed with the aid of 4 buttons: Simply alter data in the examples to adapt the program to meet your irrigation requirements. This section contains examples of weekly and cyclical irrigation programs. Removing batteries from the top end may damage the connectors. If necessary, use the flat end of a small screwdriver. Lift the lower end of the battery (2) first.Remove the battery compartment cover (1).The return battery compartment covers to its proper place, ensuring a triangle is formed on the underside of the controller.Note: battery polarity is marked in the battery compartment Insert the lower end of the battery (2) first, then press on the top end (3) to ensure the battery is firmly in place.Invert the controller and use firm pressure to lift the battery compartment cover (1).Holding the upper section of the controller above the mechanical handle, use a firm upward twist to release the controller from the skirt.Screw the swivel fitting (3) (not included) of the hydraulic valve onto the filter and use the nipple fitting (5) to connect the other end to the irrigation system. When installing the controller (4) in the irrigation system, a filter (2) (not included) must also be installed between the main irrigation system valve (1) and the controller. Installing the Controller in the Irrigation System Note: Before assembling the controller flush the irrigation system Hydraulic valve Setting Up the Irrigation Controller.If the controller appears in the app but is unable to connect, try connecting with another phone to identify the problem Resetting the controller.Close the app (which will also not run in the background) and restart it.– If the controller appears in the list, turn it off and turn on Bluetooth on the phone – If the controller does not appear in the list, restart the controller Go to the Bluetooth settings on the phone, and make sure the controller is in the list of devices.Make sure that ‘Location Services is turned on.Make sure you give permission to ‘Location Services’ when installing the app.When the pairing is complete, the phone and the controller are connected, and the app screen is displayed. ![]() Type in the pairing code and then tap ok.On the controller, a Bluetooth icon is displayed, followed by a 4-digit code. ![]() The pairing code will appear on the irrigation controller screen for about 10 seconds only If no controller is shown, tap scan for timers. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |